Rotolight Anova Spécifications télécharger pdf (Page 9)

Page 9

Encoder Switch

Rotate to Increase (+) or Decrease (-) displayed value. Click to select. Press, hold and

rotate for ‘Fast’ data entry. NB: To reset the device to the Factory Default Values,

Power up the ANOVA whilst holding down the encoder switch, it will display ‘DIST’

(Distributor), and you select either yes or no to reset the unit.

DMX In/Out

Connect to 3rd party devices or lighting console using standard 5 pin DMX wired

XLR cable. NB – To prevent accidental damage disconnect DMX Consoles or

Controller before selecting ‘DMX Master Mode’ on the ANOVA.

Power Switch

Select DC for an attached DC Input, O, or Battery for the V-Lock Plate (NB : you can

use standard V-Lock Batteries or Anton Bauer Goldmount Batteries with a QR-A200

plate adapter)

Display

This displays the Menu Item or selected value.

Programming Socket

Firmware programming socket. This is not intended for use by users, and is used to

install rmware updates by the manufacturer.

DC Input Socket

Use this 2.1mm DC socket to connect the supplied 15volt 60W AC/DC converter.

You can also run ANOVA from a 14.4volt D-Tap connector via this socket. Only use

Hardware Notes

Anova_User_Guide.indd 9 04/05/2012 14:03

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Rotolight Anova Spécifications Page 9